Standardi

SFS 6002:2025

Julkaistu

Lisää mahdolliset korjaukset ja lisäykset ostoskoriin alta.

Kieli
Toimitustavat

Soveltamisala

This document is applicable to all operation of and work activity on, with, or near electrical installations. These are electrical installations operating at voltage levels from and including extra-low voltage up to and including high voltage. This latter term includes those levels commonly referred to as medium and extra-high voltage. These electrical installations are designed for the generation, transmission, conversion, distribution and use of electrical power. Some of these electrical installations are permanent and fixed, such as a distribution installation in a factory or office complex, others are temporary, such as on construction sites and others are mobile or capable of being moved either while energised or while not energised nor charged. Examples are electrically driven excavating machines in quarries or open-cast coal sites. This document sets out the requirements for the safe operation of and work activity on, with, or near these electrical installations. The requirements apply to all operational, working and maintenance procedures. They apply to all non-electrical work such as building work near to overhead lines or underground cables as well as electrical work, when there is a risk of electrical danger. This document does not apply to ordinary persons when using installations and equipment, provided that the installations and equipment comply with relevant standards and are designed and installed for use by ordinary persons. This document has not been developed specifically to apply to the electrical installations listed below. However, if there are no other rules or procedures, the principles of this document could be applied to them: — on any aircraft and hovercraft moving under its own power, (these are subject to International Aviation laws which take precedence over national laws in these situations); — on any sea going ship moving under its own power, or under the direction of the master, (these are subject to International Marine laws which take precedence over national laws in these situations); — electronic telecommunications and information systems; — electronic instrumentation, control and automation systems; — at coal or other mines; — on off-shore installations subject to International Marine laws; — on vehicles; — on electric traction systems; — on experimental electrical research work. National Supplementary Requirement This standard is applied in Finland to the installations and systems mentioned above. Aircraft maintenance and repair work shall be carried out in accordance with the instructions and regulations of the aviation authorities. The principles of this standard may also be applied where necessary. This standard is applied in sea-going vessels, in cases, when they are being built or maintained and when the electric power supplied to them is coming from the land based grid. This standard is also applied on Finnish sea-going vessels unless no other safety rules have been ordered mandatory in these ships. Additional information of the applicability of the requirements of this standard on electric powered vehicles and work machines is given in Annex U. Specific requirements for the rolling stock of electric railways are given in the European standard SFS-EN 50153 Railway applications – Rolling stock – Protective provisions to electrical hazards and in the rules and instructions of the Finnish Transport Agency. This standard is also applied to the lifts (elevators) operating with electric power. Additional requirements on safety of work in lifts (elevators) are given in standard SFS 5880 Hissityöturvallisuus (Safety on work in the lifts (elevators)).

Julkaisun tiedot

  • Standardi julkaisijalta SFS-sähkö
  • Julkaistu:
  • Painos: 1
  • Julkaisutyyppi: IS
  • Julkaisija SFS-sähkö
  • Jakelija SFS
  • ICS 29.290
  • ICS 29.240.01
  • Vastuullinen tekijäorganisaatio
  • Tämän julkaisun valmistelusta Suomessa vastaa SESKO ry

Sidokset